Warehouse Hobbies / Enforcer Mfg. Co. does it again!

This new innovation will change Gas Model Boating as we know it. A revolutionary new concept to an age old problem, by the people who made it all possible... 

Introducing, The Solder-less Drive Cable!

Keeping this a secret has been a challenge for us for the past several months. Soldering drive cables can be a challenge, and some customers just don’t want to fool with it. We just set up to produce drive cables completely in house from raw stock. Now it is possible for us to produce a concept thought up by Tony over five years ago. Part of this design also includes a new ferrule, also of his design that threads on to the prop shaft like our standard ferrule, but rather than soldering a round cable end into the ferrule as the norm, this end has a square opening to accept a square male end. Combined with a square end on your engine...

We are talking about TOTAL solder-less drive connections from  engine, cable, to ferrule!

Let us show you how it works.

 

 

 

 

 

 

 

 

 

This system should be able to replace and be used in any application that currently uses a cable to ferrule design. This new cable system should be a permanent part of the Enforcer RTR boat line within the next couple of months. For our models, standard replacement cable (only) with dual square ends will be available for sale so you will be able to replace the flexible cable only for a fraction of the price of a complete drive cable, ferrule, and prop shaft, no longer requiring soldering. Field repairs can now be made in minutes.

The new ferrules are manufactured in a much stronger steel material with a Zink coating to prohibit rust.

Best of all is the price, It has not changed! Complete stock drive cables and custom cables with up to 18” of flex cable will continue to sell for- $19.95.

The new ferrule will also be available separately for $6.95 and replacement flex cables with double squared ends up to 18” will cost- $7.95.

We anticipate shipping by the end of October 07’.

 

We are so excited about this new innovation and sure you will too!

For more information about our new Solder-less Drive Cables, call us at: (863) 699-1231 M-F 9:30 am—5:30 pm Est.

MEASURING FOR A CUSTOM CABLE

How to measure your boat for a custom Dual Ended Square Cable if using the Enforcer SPD III

or XP-2 Drive system.

1)-Using your current cable simply install into the drive tube and be sure it is all the way in the engine / clutch receiver.

2)- With a marker make a mark on the cable exactly where it exits the transom.

3)- Remove the cable and provide us with that measurement.

 

If you are using another brand of drive system.

1)- Complete the procedures 1, 2,& 3 above and provide us with the determined length.

2)- Measure from the transom to the leading edge of your drive strut blade.

3)- Provide use with the total length of the strut blade bearing / bushing cartridge.

 

 

Call to place custom order: 800 444-1995 M-F 9:30—5:30 Est.

Fax: 24/7 (863) 699-0360    Email: whobbies@strato.net

For your convenience use the form provided to save measurements, email, or fax your order.